3-16
Setting UV mode
7
Press to select the control method.
If you selected “FULL” : Printing is performed with the LED outside the print range lit up when the print
begins and ends.
If you selected “PRINT” : Printing is performed with the LED outside the print range lit up when the print
begins and ends.
8
Press the key.
• If you selected “FULL” in Step 7, proceed to Step 16.
9
Press to input the left side inside cure lamp
scale position.
Set Value : 0 to 80mm (The LED UV lamp’s normal position is “30mm”.)
10
Press the key.
11
Press to input the left side outside cure
lamp scale position.
Set Value : 0 to 245mm (The LED UV lamp’s normal position is “80mm”.)
12
Press the key.
13
Press to input the left side inside cure lamp
scale position.
Set Value : 0 to 80mm (The LED UV lamp’s normal position is “30mm”.)
14
Press the key.
15
Press to input the left side outside cure
lamp scale position.
Set Value : 0 to 245mm (The LED UV lamp’s normal position is “80mm”.)
16
Press the key.
17
Press the key several times to end the setting.
To Next Page
Loading...
