3-20
Setting MAPS1 Function
1
Press the key in LOCAL.
2
Press to select [SET UP].
3
Press the key.
4
Press to select [MAPS].
5
Press the key.
6
Press to select MAPS1.
•Set Value：MAPS1, MAPS2, OFF
7
Press the key.
• If you selected MAPS2 or OFF in step 5, proceed to step 8.
8
Press to change print speed.
• Set Value:-50 to +50%
9
Press the key.
10
Press the key several times to end the setting.
• When you change the speed, nozzle recovery effect cannot work in some cases. Use it
after checking.
To Next Page
Loading...
