MIMAKI JFX550-2513 - Page 140

Chapter 5 Troubleshooting
140
Error
numbe
r
Message Cause Corrective action
0182 PCB H22 • The HDC PCB 2 could not
be detected.
0189 COM VOLT • A problem was detected
with the COM voltage.
018A Main PCB V_CORE • A problem was detected
with the main PCB power
supply circuit.
• Turn off the control PC, then turn off
the main power. Wait briefly before
turning the control PC and the main
power back on.
018B Main PCB V1R5B
018C Main PCB V12
018D PCB EXIO • A control PCB problem
occurred.
018E FLS NOT COMP • A problem was detected
with the print head control.
018F OFFSET WAVE
0190 Main PCB V_V1 • A problem was detected
with the main PCB power
supply circuit.
019D HDC VOLT ERROR • A problem was detected
with the PCB.
019E HDC FUSE ERROR • Blown PCB fuse
019F LED CONNCT ERR • The UV-LED PCB could
not be detected.
01A2 PCB DRV1 • DRV PCB 1 could not be
detected.
01A3 PCB DRV2 • DRV PCB 2 could not be
detected.
01A4 PCB DRV3 • DRV PCB 3 could not be
detected.
01BF PCB MAIN-F2/F3 • Blown main PCB fuse.
01E7 PCB INKCTRL1 • A control PCB problem
occurred.
01E8 PCB INKCTRL2
01EB PCB BIO
0201 COMMAND • A communication error
was detected between the
control PC and printer.
0202 PARAMETER
0203 Ment Command
030C SCAN DATA TIMEOUT
0310 PORT OPEN ERROR • MAIN-PE FW
communication error The
Ethernet ports cannot be
opened between PCBs.
0311 ACK ERROR • MAIN-PE FW
communication error ACK/
NAK cannot be received
from PE-FW.