Chapter 1 Before Use
52
l
PrepareInk bottle
1
Shake the Ink bottle to the left and right slowly at least 20 times.
• Tighten the ink bottle lid securely, then shake the bottle slowly from left to right to ensure that the
ink moves inside, holding the ink bottle lid with a paper towel.
• Shake the bottle slowly. If the bottle is shaken violently, there is a risk of ink leakage or
nozzle clogging due to air getting inside the ink.
• For partially used ink bottles, tilt the bottle vertically and shake it gently.
2
Remove the ink bottle lid.
• If there is a seal covering the mouth of the ink bottle
(1) Use a tool such as a cutting knife to cleanly cut out a circular piece of the seal. If any
pieces of the seal are leftover, it may cause the ink to leak.
(2) Take care not to damage the mouth of the ink bottle. Any damage may result in ink
leakage.
(3) Take care to prevent any pieces of the seal from dropping into the bottle. If a bottle
that contains pieces of the seal is used, there is a risk that it will block the bottle cap
and interrupt the supply of ink.
3
Attach the special cap to the ink bottle.
To Next Page
Loading...
