Chapter 2 Printing
91
• Using this function does not change the time required for printing.
• If the print conditions are set to the minimum number of passes in the RIP software, the nozzle
recovery function will be disabled.
• Recovery functions during image printing when nozzle recovery has been registered and
enabled, but recovery will not be applied to print patterns such as test printing and dot position
correction.
l
Checking nozzle recovery settings
The nozzle recovery operation conditions set in "Enabling nozzle recovery"(P. 90) can be checked as
follows:
1
Check the Nozzle recovery setting ("On" or "Off") in "Machine setting" on the print conditions
screen.
2
Check the nozzle recovery setting ("Off", "Disabled", or "Enabled") on the JOB STATUS check
screen after starting printing.
• "Disabled" is displayed when the Nozzle recovery setting is "On" and some of the clogged nozzles
cannot be recovered.
• "Enabled" is displayed when the Nozzle recovery setting is "On" and all of the clogged nozzles can
be recovered.
Nozzle recovery confirmation message
l
Setting "Nozzle recovery confirmation message"
"Nozzle recovery confirmation message" is a function that displays a print start confirmation message
corresponding to the registered nozzle clogging information. When Nozzle recovery is turned on, enabling
"Nozzle recovery confirmation message" causes a message to be displayed to confirm whether you wish to
start printing. The message details are described in "Nozzle recovery confirmation message
details"(P. 93).
2
To Next Page
Loading...
