Chapter 2 Printing
93
l
Nozzle recovery confirmation message details
A confirmation message is displayed before the start of printing to continue with nozzle recovery when
certain conditions apply. There are three different patterns for the confirmation messages, as follows:
(1) For print conditions in which nozzle recovery does not apply
→ Indicates that printing will be performed in Draft mode (fastest scan mode using the fewest
passes).
Change the following settings to enable nozzle recovery:
・ Increase the number of passes
・ Reduce the MAPS speed
・ Change the scan speed from "High" to "Normal"
(2) When nozzles exist that cannot be recovered using nozzle recovery (Case 1)
→ Displayed in cases where nozzle recovery is effective by reducing the MAPS speed even
when the nozzles to assist the clogged nozzles are themselves clogged.
Selecting [Apply settings and continue print] on the message screen reduces the printing
speed, but allows printing to be performed by enabling nozzle recovery.
• For information on MAPS settings, refer to "Setting 1 Menu"(P. 104).
(3) When nozzles exist that cannot be recovered using nozzle recovery (Case 2)
→ Displayed when nozzle recovery is not practical even by reducing the MAPS speed.
Change the following settings to enable nozzle recovery:
・ Increase the number of passes
・ Change the scan speed from "High" to "Normal"
2
To Next Page
Loading...
