MIMAKI jV100-160 - Page 128

Chapter 5 Dealing with Problems
128
Error
number
Message Cause Corrective action
63c Ink level 0 • The ink level is now 0 ml. • Replace with new ink.
"Replacing Ink"(P. 39)
64C NCU error • The function cannot be
executed due to an error.
• Turn off the power on the machine
and turn it on after a while.
"Turning Off the Power"(P. 31)
650 NCU CONNECT • A problem was detected
with the NCU connection.
651 REPLACE NCU • A problem was detected
with the nozzle clogging
assessment.
• The NCU must be replaced.
Contact your local distributor, our
sales office, or service center.
652 NCU detection error
(HW)
• A problem was detected
with the nozzle clogging
assessment.
• Clean the NCU. "NCU
Cleaning"(P. 95)
653 NCU NZK CHK (Mark)
654 NCU CENTER POS • Printing position
adjustment failed.
655 NCU FLUSH POS
656 NCU SN Adjst error • Sensor sensitivity
adjustment failed.
657 Replace NCU Ink Pad • The NCU ink absorber is
full.
• The NCU ink absorber must be
replaced. Contact your local
distributor, our sales office, or
service center.
658 NCU Sensor Lv Low • The sensor’s sensitivity is
impaired.
• Clean the NCU. "NCU
Cleaning"(P. 95)
• Replace the NCU if the error does
not clear. Contact your local
distributor, our sales office, or
service center.
65b NCU Sens Adj Err H • Sensor sensitivity
adjustment failed.
65c NCU Sens Adj Err L
702 Thermistor Connect • A problem was detected
with the thermistor
connection.
• Turn off the power on the machine
and turn it on after a while.
"Turning Off the Power"(P. 31)
710 Heater Temp Error • A problem was detected
with the heater
temperature.
• This error will be automatically
resolved. If not, Turn off the power
on the machine and turn it on after a
while. "Turning Off the
Power"(P. 31)
901 INVALID OPERATION • The function cannot be
executed due to an error.
• Check the error details.
902 Data Remain • Print (RIP) data was
received.
• Switch to REMOTE mode and start
printing or clear the data and abort
printing.
90d No Head Select • A problem was detected
with the print head.
• Turn off the power on the machine
and turn it on after a while.
"Turning Off the Power"(P. 31)
90f Print Area Short • The media is too small for
the print.
• Replace with wider or longer media.
• If the printable area is reduced due
to a shift in the origin, move the
origin to increase the size of the
printable area.