Chapter 3 Mchine setting
3-14
When using 600 cc cartridge for the
first time
When the 600 cc cartridge is set in the slot of the ink
station, the weight registration function of the eco case
automatically starts.
1
Measure the weight of the eco case.
• Measure the weight of the eco case only in
advance.
• If the 600 cc ink pack is in the eco case, remove
the 600 cc ink pack and then perform
measurement.
2
Set the 600 cc cartridge in the ink station.
• Mount the 600 cc ink pack and the ink chip on the
eco case, and set it to the ink slot.
• The input screen for the weight of the eco case
will be displayed.
3
Press to input the
weight of the eco case.
• Press the [][] keys to move to another digit.
•Press the [][] keys to input the weight.
4
Press the key.
• For setting 600 cc cartridges in multiple slots,
repeat the procedures in Step 2 and 3.
• After all registration is completed, the device will
return to the status before the weight registration
function was initiated.
When the eco case weight is changed
When the case weight is changed by replacing the eco
case, register the weight of the eco case in the following
procedures.
1
Press the
(MENU)
(twice)
key in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press to select “600cc
Cartridge”, and press the key.
• When the 600 cc cartridge is not set,
“ 600 cc Cartridge” will not be displayed.
• It is recommended to measure the weight of the
eco case in advance and then perform the
procedure from the Step 3.
3
Press the key.
4
Press and
(page >)
key,
to select the [Slot].
• The selected slot is highlighted.
5
Press the key.
6
Press to input the
weight of the eco case.
• Press the [][] keys to move to another digit.
•Press the [][] keys to input the weight.
7
Press the key.
• The slot selection screen is displayed again.
• When you want to register the weight of another
slot continuously, repeat the Step 4 to select a
slot.
8
Press the key several times
to end the setting.
Registering the total weight of the ink
cartridge
When you have to correct the amount of remaining ink,
follow the steps below to register the total weight of the ink
cartridge.
1
Press the
(MENU)
(twice)
key in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press to select “600cc
Cartridge”, and press the key.
• When the 600 cc cartridge is not set,
“ 600 cc Cartridge” will not be displayed.
• It is recommended to measure the weight of the
eco case in advance and then perform the
procedure from the Step 3.
3
Press , and press the key.
4
Press and
(page >)
key,
to select the [Slot].
• The selected slot is highlighted.
5
Press the key.
6
Press to input the
weight of the cartridge.
• Press the [][] keys to move to another digit.
•Press the [][] keys to input the weight.
7
Press the key.
• The slot selection screen is displayed again.
• When you want to register the weight of another
slot continuously, repeat the Step 4 to select a
slot.
8
Press the key several times
to end the setting.
To Next Page
Loading...
