MIMAKI JV300-130 - Changing the Joints

© 2014 MIMAKI ENGINEERING CO.,LTD. 5.1 P.2
R.1.2
1
2
3
4
5
6
7
INSTALLATION GUIDE > Ink Set > Changing the Joints
Model
JV300
Issue
2014.04.11
Revised 2014.06.19 F/W ver.
1.00
Remark
1.2
Rev.
5.1 Changing the Joints
Joint change procedure
 Work procedures
1. Remove cartridge rear cover from the back panel of the main
unit.
 Use protective glasses and gloves during work.
Depending on the working condition, ink may reach your eyes or your skin may be roughed due to
ink.
 For the tube route, refer to the following. (The figure viewing from the rear of machine)
6+W+Si ink set
4-color ink set
8-color ink set
6+W ink set
4-color ink set
(Sb53)
4+Dk ink set
(Sb53)
6-color ink set
(Sb53)
6+Dk ink set
(Sb53)
Cartridge rear cover