MIMAKI JV300-130 - Page 32

© 2014 MIMAKI ENGINEERING CO.,LTD. 5.2 P.9
5.2 Adjustments When Using Sublimation Transfer Ink
R.1.0
1
2
3
4
5
6
7
5. Remove the carriage cover.
6. Remove the under cover R.
7. Loosen the four screws in the left figure.
8. Pull out the CPS angle spacer 1.
9. Insert the CPS angle spacer 1 pulled out under the CA right
base.
Carriage cover
Under cover R
CPL angle spacer 2
 Use the accessory driver (150mm) to loosen the
CPL angle spacer 2.
CPS angle spacer 1
CA right base
INSTALLATION GUIDE > Ink Set > Adjustments When Using Sublimation Transfer Ink
Model
JV300
Issue
2014.04.11
Revised F/W ver.
1.00
Remark
1.0
Rev.