© 2014 MIMAKI ENGINEERING CO.,LTD. 5.2 P.10
5.2 Adjustments When Using Sublimation Transfer Ink
R.1.0
1
2
3
4
5
6
7
10. Pull out the CPL angle spacer 2.
11. Insert the CPL angle spacer 2 pulled out under the CA left
base.
12. Tighten the four screws loosened in the Step 6.
CA left base
CPL angle spacer 2
INSTALLATION GUIDE > Ink Set > Adjustments When Using Sublimation Transfer Ink
Model
JV300
Issue
2014.04.11
Revised F/W ver.
1.00
Remark
1.0
To Next Page
Loading...
