© 2014 MIMAKI ENGINEERING CO.,LTD. 5.2 P.11
5.2 Adjustments When Using Sublimation Transfer Ink
R.1.0
1
2
3
4
5
6
7
Head Height Adjustment
Before performing this work, check the items below:
• The clamp lever is at the lower position.
• The head gap is 2mm (the head height lever is at the lower position).
Work procedures
1. Loosen the screw of cover fulcrum pin BKT which is at the
left side of front panel cover M.
2. Shift the cover fulcrum pin BKT to right, and remove the front
panel cover M.
3. Remove the front cover.
Front panel cover M
Screw of Cover fulcrum pin BKT
INSTALLATION GUIDE > Ink Set > Adjustments When Using Sublimation Transfer Ink
Model
JV300
Issue
2014.04.11
Revised F/W ver.
1.00
Remark
1.0
To Next Page
Loading...
