© 2014 MIMAKI ENGINEERING CO.,LTD. 5.2 P.13
5.2 Adjustments When Using Sublimation Transfer Ink
R.1.0
1
2
3
4
5
6
7
8. Remove the carriage height adjustment plate, and attach it to
the P-head up and down slider.
9. Tighten the head lock screw with a standard screw drive or a
coin.
10. Put back Removed covers at the original positions.
キャリッジ高さ調整板
P
ヘッド上下スライダー
P head up and down slider
Carriage height adjust plate
Carriage height adjust plate
At shipping, the height adjustment spacers (3
types) are not inserted.
The number of spacers used is different
depending on the media used by a user.
Be sure to match the carriage height-adjustment
plate to the number of sheets of the spacers which
are inserted at the station.
Media thickness Number of Spacers used
At shipping 0
3 mm ~ 4 mm 1
4 mm ~ 5 mm 2
Head lock screw
Head lock screw
INSTALLATION GUIDE > Ink Set > Adjustments When Using Sublimation Transfer Ink
Model
JV300
Issue
2014.04.11
Revised F/W ver.
1.00
Remark
1.0
To Next Page
Loading...
