MIMAKI JV300-130 - Setting the Voltage Selector

© 2014 MIMAKI ENGINEERING CO.,LTD. 6.1 P.2
R.1.0
1
2
3
4
5
6
7
INSTALLATION GUIDE > Power Supply Related > Setting the Voltage Selector
Model
JV300
Issue
2014.04.11
Revised F/W ver.
1.00
Remark
1.0
Rev.
6.1 Setting the Voltage Selector
 Outline
The device voltage should be switched to 100 to 120V or 200 to 240V to match the power supply voltage.
1. Switch the voltage selector switch to the side for the voltage
you are using.
 Because the device may be damaged by an incorrect setting, do not change the setting after
installation.
 220V at shipping.