© 2014 MIMAKI ENGINEERING CO.,LTD. 6.2 P.3
R.1.1
1
2
3
4
5
6
7
INSTALLATION GUIDE > Power Supply Related > Connecting the Power Cable
Model
JV300
Issue
2014.04.11
Revised
2014.05.08
F/W ver.
1.00
Remark
1.1
6.2 Connecting the Power Cable
Outline
This device connects to the included power cable.
If you do not use the included power cables, use cable that match your region.
Connect the power cables into a power outlet with the following specifications.
1. Insert the power cable clamp into the power supply box.
300 model : Power cable x 2
2. Insert the power cable into the inlet of this device.
3. Lock the power cable.
Run the power cable through the clamp, and lock the clamp
until it clicks.
4. Insert the power plug into a plug socket.
Vo l t a g e AC100 - 120V / 220 - 240V
Frequency 50/60Hz
Capacity
AC100 - 120V: 1440W
AC220 - 240V: 1920W
Always connect the cables to a power outlet near the device so that the cables can be easily removed.
When plugging the cables into the power outlets, connect the cable into outlets on a separate circuit
from other devices. Because of the large power consumption, the power supply breaker may be
tripped.
Power supply cables should be connected to an earthed outlet. Otherwise, there is a risk of electrical
shock or of damaging the device.
When connecting the power cables, ensure that the power switch of the device is off.
To Next Page
Loading...
