© 2014 MIMAKI ENGINEERING CO.,LTD. 6.4 P.5
R.1.1
1
2
3
4
5
6
7
INSTALLATION GUIDE > Power Supply Related > Turning the Power Off
Model
JV300
Issue
2014.04.11
Revised
2014.05.08
F/W ver.
1.00
Remark
1.1
6.4 Turning the Power Off
Outline
When turning the power off, check that the unit is not receiving data, and there is no remaining un-output data.
Furthermore, check that the head is in the capping station.
1. Turn the power off, by giving the [END/POWER] key a long
press.
2. The confirmation screen of power OFF is displayed.
If you turned the power off without performing capping, turn the power back on again. Return the head
to the capping station to prevent the head from drying out.
If the power is turned off during plotting, the head might not be parked in the capping station. Leaving
the head for a long time without capping may cause nozzle blockages.
Do not turn off the main power switch on the side, as this will stop the function for preventing nozzle
blockages from functioning.
To Next Page
Loading...
