MIMAKI JV300-130 - Outputting Plots

1
2
3
4
5
6
7
© 2014 MIMAKI ENGINEERING CO.,LTD. 7. P.1
R.1.0
INSTALLATION GUIDE > Outputting Plots
Model
JV300
Issue
2014.04.11
Revised F/W ver.
1.00
Remark
1.0
Rev.
7. Outputting Plots
 List of work procedures
Work operation Description Refer to
1 Initial Ink Fill Execute the initial ink fill 7.1 (p.2)
2 Test Print Check that there are no plotting problems, such as missing nozzles or bent paths 7.2 (p.8)
3 Cleaning the Heads Carry out if a drawing failure occurs in the test print. 7.3 (p.10)
4 Dot Position Adjustment
(Service mode)
Execute dot position adjustment if misalignments occur during bidirectional plotting 7.4 (p.11)
5 Dot Position Adjustment
(User menu)
Execute dot position adjustment if misalignments occur during bidirectional plotting 7.5 (p.14)