© 2014 MIMAKI ENGINEERING CO.,LTD. 7.1 P.6
7.1 Performing the Initial Ink Fill
R.1.1
1
2
3
4
5
6
7
Working procedure 4 (Ink filling)
17. Install each ink cartridge in the ink station.
18. Press [ENTER], and start the ink filling.
FIRST FILL UP
Set Cartridges
■■■■■■■■
FIRST FILL UP
Start
CLEANING
Please Waint…
LOCAL
MENU
TEST PRINT/
CLEANING
REMOTE
FIRST FILL UP
Filling up
Please Waint…
The color of ink to insert into each ink station is
predetermined.
Install the ink cartridges to match the cartridge labels
below the ink station.
When the correct ink cartridge is set, it moves to
the next screen. (The ink IC is recognized.)
If the ink filling could not be performed normally by the operation described above, execute the
following [Cleaning] or [Ink filling (Maintenance)].
When you performed [5.2 Adjustments When Using Sublimation Transfer Ink -P.8], adjust the head
below after ink filling has been completed.
MAINTENANCE MANUAL 4.2.1 SLANT ADJUST
4.2.2 STAGGER ADJUST
4.2.4 DROP. POS
INSTALLATION GUIDE > Outputting Plots > Performing the Initial Ink Fill
Model
JV300
Issue
2014.04.11
Revised
2014.06.19
F/W ver.
1.00
Remark
1.1
To Next Page
Loading...
