MIMAKI JV300-130 - Page 48

© 2014 MIMAKI ENGINEERING CO.,LTD. 7.1 P.7
7.1 Performing the Initial Ink Fill
R.1.0
1
2
3
4
5
6
7
 Outline of Cleaning
 Outline of Ink filling (Maintenance)
Carry out by selecting the corresponding color if it could not be recovered by the cleaning.
 Working procedure
1. Select [FILL UP INK].
2. Select the nozzle having the nozzle missing.
3. Press the [ENTER] key.
When nozzle missing is less Normal
When nozzle missing is many Hard
 For the working procedures, refer to [7.3 Cleaning the Heads].
When nozzle missing is less Soft
When nozzle missing is many Normal
FILL UP INK
・ SOFT
・ NORMAL
・ HARD
Select Fill up Color
・ M
・ C
・ Y
・ K
FILL UP INK
Filling up Please wait
INSTALLATION GUIDE > Outputting Plots > Performing the Initial Ink Fill
Model
JV300
Issue
2014.04.11
Revised F/W ver.
1.00
Remark
1.0
Rev.