MIMAKI JV300-130 - Adjustment of the Station Height

© 2014 MIMAKI ENGINEERING CO.,LTD.
4.3.3 P.1
1
2
3
4
5
6
7
8
R.1.0
4.3.3 Adjustment of the Station Height
 Outline
Adjust the height of the station.
 Procedure
1. Remove the Cover R, Cover R2 and Undercover R.
2. Loosen the 4 screws used for CA base adjustment.
3. Loosen the hexagon socket head screws (x3) and make an
adjustment to set their thickness gauge at 5 mm, then tighten the
nuts.
4. Tighten up 4 loosened screws used for CA base adjustment
CA base
Loosen x4
hexagon socket head screw x3
5mm
Adjust by rotate x3
Tighten after
adjusting
MAINTENANCE MANUAL > Adjustment Items > Mechanical Adjustment > Adjustment of the Station Height
Model JV300-130/160 Issued 2014.05.30 Revised F/W ver. 1.00 Remark
1.0
Rev.