3-12
Chapter 3 Machine setting
Setting a AUTO Power-off
When no operation has been performed for the set time,
the power supply is automatically turned “OFF”.
1
Press the
(MENU)
(twice)
key in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press to select “AUTO POWER
OFF”, and press the key.
3
Press to select a set value, and
press the key.
• Set Value : none, 10 to 600min
4
Press the key several times
to end the setting.
Setting a AUTO Power-on
Applicable model: Plus series (FW Ver.1.30 or
later)
The machine starts automatically at the set day of the
week and time.
Combining the "AUTO Power-on" setting with the heater
setting shortens the waiting time until print preparation.
1
Press the
(MENU) (twice
)
key in local mode.
• MACHINE SETUP MENU will be displayed.
2
Press to select “AUTO POWER
ON”, and press the key.
3
With "SETUP" selected, press the
key.
4
Press to select a set value, and
press the key.
• Set Value: ON/ OFF
ON: Auto Power-on
OFF: Not Auto Power-on
5
Press to select “Time”, and press
the key.
6
Press to set the auto
power-on time and press the key.
• Set Value: 0:00 to 23:59 (24 hour system, 1
minute unit)
: Change in hours.
: Change in minutes.
7
Press to select “Day”, and press
the key.
8
Press to select the day of the
week to change the setting, and press
key to switch ON/OFF.
• Set Value: ON/ OFF (Each day of the week)
ON: Auto power-on on the specified day of the
week.
OFF: Do not turn on auto power-on the specified
day of the week.
9
After setting ON/OFF for all days, press the
key.
10
Press the key several times to
end the setting.
EVENT MAIL
Server Setup
( P.3-17)
POP3 Address
*3
- Set the POP server.
APOP *3 - Set ON/ OFF of APOP.
Transmit Test
(P.3-18)
Send the test e-mail.
Auto Remote
(Plus series)
(P.3-19)
ON / OFF ON
When data is received in the local mode, it
automatically switches to the remote mode and
sets whether to start printing.
RESET
( P.3-19)
-
All setting values are returned to the status
default.
*1. Settable when both of DHCP and AutoIP are [OFF]
*2. Settable only when Auth. is not OFF
*3. Settable only when Auth. is POP before SMTP
Function name Set value Default Meaning
• If you want to turn off the power automatically,
use the "AUTO Power-off" function.
To Next Page
Loading...
