5-5
1
2
2
2
5
6
Chapter5 Troubleshooting
Warning / Error Messages
If some trouble occurs, the buzzer sounds and the display shows a corresponding error message.
Take an appropriate remedy for the displayed error.
Warning messages
Errors when performing operations
Message displayed in LOCAL
Message Cause Solution
Operation cannot be performed because
no media is detected.
• Execute after media is detected.
The motor is OFF after the cover was
opened etc.
• Return to LOCAL and execute the operation
after completion of initialization.
An ink error occurred.
• Execute the operation after replacing with a
new ink cartridge.
The front cover or the maintenance
cover is opened.
• Execute the operation after closing the
cover.
Data was received.
• Execute the operation after executing data
clear.( P.2-13)
Message Cause Solution
Multiple ink errors (unusable ink) have
occurred, making it impossible to feed
ink (printing and cleaning, etc.).
Replace with a new ink cartridge.
The waste ink tank count has exceeded
the prescribed amount.
Check the amount of waste ink in the waste
ink tank.
Conduct maintenance and waste ink tank
replacement, and reset the amount of waste
ink.
The used count of wiper has exceeded
the prescribed number.
Execute maintenance, station maintenance
and wiper exchange and replace the wiper.
No media is set. Or, the sensor is faulty.
Set the media.
If the same error message still appears after
setting the media, contact your local distribu-
tor, our sales office or our call center.
Print data is received in LOCAL.
Shift to REMOTE and execute printing.
Or, execute data clear and cancel printing.
INVAILD OPERATION
:MEDIA UNDETECT
INVAILD OPERATION
:MOTOR POWER OFF
INVAILD OPERATION
INK ERROR
INVAILD OPERATION
COVER OPEN
INVAILD OPERATION
DATA REMAIN
To Next Page
Loading...
