Chapter5 Troubleshooting
5-8
An error occurred in the main PCB .
• Turn off the power to the machine and turn it
on after a while.
• If it is displaying again, contact your local
distributor, our sales office or our call center.
An error occurred in the COM16/32IO
PCB .
An error occurred in the SLIDER2H PCB
.
PRAM board connection failure (includ-
ing unconnected),
Or breakdown.
* Online printing cannot be performed
when this error occurs.
For other functions including mainte-
nance function
It can be used.
• Turn off the power to the machine and turn it
on after a while.
• When displaying again, contact your local
distributor, our sales office, or service center.
The machine received some data other
than print data.
Or, an error occurred in the transmitted
print data.
• Securely connect the interface cable in posi-
tion.
• Use an interface cable conforming to the
specifications.
An error occurred in the transmitted print
data.
An error occurred in the communication
of USB.
• Turn the main power off once and turn it
back on after some time.
• If it is displaying again, contact your local
distributor, our sales office or our call center.
An excessive load was applied to the X
motor.
An excessive load was applied to the Y
motor.
Message Cause Solution
To Next Page
Loading...
