3-47
Machine settings
3
Convenient use
5
Press the key.
6
Press the key.
• Usable amount of remaining ink is recalculated.
• The contents displayed differ depending on the amount of remaining ink.
(1) When ink still remains
• Return to the local mode or the remote mode.
• [Ink Level] warning disappears and the state of the 600 cc
cartridge that Ink Level Set function was performed changes
to [INK NEAR END] warning.
• [INK NEAR END] warning can be checked on the guidance
function. ( P.3-61)
(2) When no ink remains
• A message for replacing the ink pack is displayed.
• Press the key to return to the local mode
or the remote mode.
• [Ink Level] warning is still displayed and the state
of the 600 cc cartridge that Ink Level Set function
was performed changes to [INK END] warning.
• [INK END] warning can be checked on the guid-
ance function. ( P.3-61)
When an error occur in the Step 6
This function stores the calculated quantity of remaining ink in the ink chip of the 600cc cartridge.
If the 600cc cartridge is removed or there is a problem on the contact of this
device and the ink chip, the data storage in the ink chip cannot be performed.
In this case, the message on the right will be displayed.
If the message is displayed, reinsert the 600cc cartridge and follow the proce-
dures from the Step 2 again.
• Once a message for replacing the ink pack appears, immediately replace the target ink pack
with a new one. (Usable ink has been used up.)
• Ink in the ink pack cannot be completely used up. To prevent ink supply errors, about 30 cc of
ink must remain in the ink pack. (Before shipping, more than 630 cc of ink is filled in the ink
pack to use 600 cc.)
To Next Page
Loading...
