4-17
Maintaining Capping station
4
Routine Maintenance
Executes the NOZZLE PROTECT function automatically
You can set the status to enter the nozzle protection automatically (auto-execute function of NOZZLE PRO-
TECT) in case the device is not used for a certain amount of time.
In the nozzle protection status, NOZZLE PROTECT can be automatically executed regularly.
To use the auto-execute function of NOZZLE PROTECT, set the following items.
• On Time : Time from the stop of the device to the start of the nozzle protection status.
• Interval : ÉmExecution interval of NOZZLE PROTECT in the nozzle protection status.
1
Select [AutoNZL.PROTECT] of the maintenance menu.
(1) Press the key in the local mode.
(2) Select [MAINTENANCE] by pressing the keys then press the key.
(3) Select [AutoNZL.PROTECT] by pressing the keys.
2
Press the key.
3
Select [ON Time] by pressing the
keys.
• The machine not being used means that it is in the standby status or the status that the power
supply switch under the operation panel is OFF (the sleep status).
• The followings are the examples (three patterns) if you set the time length until the NOZZLE
PROTECT function is executed to “16h”.
In use On standby *1
Executing NOZZLE PROTECT
In use In sleep status *1
In use
On standby *1
Power switch OFF
In sleep status *1
Power switch OFF
*1 : If the time length set in P.4-31 “Setting Routine operations” and P.4-28 “Preventing nozzle clogging
while power-off” has passed, maintenance operation is executed automatically.
*2 : In the nozzle protection status, a maintenance function set at P.4-28 “Preventing nozzle clogging while
power-off” does not work.
After entering the nozzle protection status, this machine automatically performs NOZZLE PROTECT
regularly.
Executing NOZZLE PROTECT
Executing NOZZLE PROTECT
In the nozzle protection status *2In the nozzle protection status *2
In the nozzle protection status *2
In the nozzle protection status *2
To Next Page
Loading...
