MIMAKI JV33-130BS - Page 136

Maintaining Capping station
4-18
4
Press the key.
5
By pressing the keys, set the
time length until the NOZZLE PROTECT
is executed.
• Set value : OFF, 1 to 24 hours
6
Press the key.
• “ON Time” setting ends. Following this, set “Inter-
val”.
• “Interval” is set to seven days as default. If chang-
ing is not needed, press the key several
times to end the setting.
7
Select [Interval] by pressing the
keys.
8
Press the key.
9
Press the keys to set an exe-
cution interval (number of days) of
NOZZLE PROTECT.
• Set value : OFF, 1 to 14 days
10
Press the key.
• Press the key several times to end.
• If maintenance washing liquid has not been filled in the machine,
the screen on the right is displayed in the Step 4. Fill maintenance
washing liquid and execute procedures from the Step 1 again.
Au t oNZL . PROTECT
ON T i me = 1
6 h
Au t oNZL . PROTECT
ON T i me = 1 2 h
Au t oNZL . PROTECT
ON T i me < e n t >
Au t oNZL . PROTECT
Interval <ent>
Au t oNZL . PROTECT i n t v l
ON T i me = 7 d
Au t oNZL . PROTECT i n t v l
ON T i me = 1
0 d
MA I NT ENANCE
Au t oNZL .CUSTODY<en t >
** Washing l iquid **
* * un- f i l l i ng up . * *