MIMAKI JV33-130BS - Page 175

5-11
Warning / Error Messages
5
Troubleshooting
Message Cause Solution
An error occurred in the wiper con-
trol.
Turn off the main power to the machine
and turn it on after a while.
If the same error message appears again,
contact your local distributor to call for ser-
vice.
Paper could not be detected.
The media set position or media
itself is not proper.
If the same error message appears again
even after setting the media properly, con-
tact your local distributor to call for service.
The set position of the media is not
proper. The media detection has not
completed.
Set the media to the proper position again.
( P.2-8, P.2-14)
Y-origin could not be detected.
Turn off the main power to the machine
and turn it on after a while.
If the same error message appears again,
contact your local distributor to call for ser-
vice.
The ambient temperature is out of
the usable temperature range (too
low).
Adjust the room temperature of the
machine.
To continue operation without changing
the ambient conditions, press the
key.
The ambient temperature is out of
the usable temperature range (too
high).
There is a slot where no cartridge
has been inserted.
Set a cartridge.
An error occurred on the head unit
memory.
Turn off the main power to the machine
and turn it on after a while.
If the same error message appears again,
contact your local distributor to call for ser-
vice.
A SD-RAM of the size required for
the machine has not been
equipped.
Turn off the main power to the machine
and turn it on after a while.
If the same error message appears again,
contact your local distributor to call for ser-
vice.
(When a usable SD-RAM is available, the
machine can be started as is. However, a
printing speed may be slow depending on
resolution. )
An abnormal temperature of the
media heater was detected.
Turn off the main power to the machine
and turn it on after a while.
If the same error message appears again,
contact your local distributor to call for ser-
vice.
An abnormal temperature of the
head heater was detected.
The head heater is disconnected.
Trouble has occurred with the
thermistor of the head heater.
***** ERROR 46 *****
WI PER
***** ERROR 50 *****
MED I A WI DTH SENSOR
***** ERROR 50 *****
MED I A SET POS I T I ON L
***** ERROR 50 *****
MED I A SET POS I T I ON R
***** ERROR 51 *****
Y-ORIGIN
**** ERROR 120 ****
ROOM TEMP LOW ( XX
°
C)
**** ERROR 121 ****
ROOM TEMP H I GH ( XX
°
C)
**** ERROR 144 ****
CARTR I DGE SET !
**** ERROR 200 ****
HEAD MEMORY (----)
**** ERROR 203 ****
SDRAM S I ZE
**** ERROR 211 ****
HeaterTEMP(--/--/--)
**** ERROR 211 ****
HeadWARM.TEMP.(----)
**** ERROR 211 ****
HeadWARM.BREAK(----)
**** ERROR 211 ****
HeadWARM.THERM(----)