MIMAKI JV33-130BS - Page 33

The procedures from the ink and media preparation to drawing
and the setting procedures are described.
User type ........................................ 2-2
Set items registrable to User type ..... 2-2
Using the registered user type .......... 2-2
Workflow......................................... 2-3
Turning the power ON/OFF........... 2-4
Turning the power ON ....................... 2-4
Turning the power OFF ..................... 2-5
Setting medias ............................... 2-6
Useable medias ................................ 2-6
Adjusting the head height .................. 2-6
Setting a roll media ...........................2-8
Take-up device ................................ 2-13
Setting leaf media ........................... 2-14
Changing the printing origin ............ 2-16
Preparing Heaters ........................ 2-18
Changing temperature settings of
Heater ............................................. 2-18
Confirming the Heater temperature 2-19
Test printing ................................. 2-20
Test printing .................................... 2-20
Head cleaning ................................. 2-21
Drawing data................................. 2-22
Starting the print ............................. 2-22
Stopping the print temporarily ......... 2-23
Erasing the received data
(Data clear) ..................................... 2-23
Cutting a media ............................... 2-24
CHAPTER 2
Basic Operations