2-7
Setting medias
2
Basic Operations
3
Adjust the height-adjusting lever
according to the media.
• Adjust the position of the lever, referring to "For
the adjusting lever and the range".
• Set the height-adjusting lever to the highest stage
or the lowest stage. Setting it to the intermediate
height, a printing fault can result.
4
Keeping the height adjusting lever held
at the aforementioned position, tighten
the two screws.
• Be sure to fasten the screws, pressing the height-
adjusting lever, otherwise the head can not be
secured at the correct position.
• Fasten the screws securely.
5
Return the carriage to the station posi-
tion.
For the adjusting lever and the range
Height adjusting
lever
Head height Switching area
Thin : light-weight
2mm
(The set position at shipping)
Switch by user
Thick : heavy-weight 3mm
• Set the lever to "Thick" when a thicker media such as a tarpaulin or FF is used.
• Set the lever to the lower stage (Thick) if dust is likely to gather in the head or the head is likely
to rub on the media to leave ink on it.
To Next Page
Loading...
