Test printing
2-21
2
Basic Operations
Head cleaning
Three head cleaning types are available. Select it depending on the result of pattern drawings.
NORMAL: Select this if any line is missing.
SOFT : When only head wiping is desirable. (in case of bent lines)
HARD : Select this if inferior printing cannot be improved even by [NORMAL] or [SOFT] cleaning.
1
In the local mode,
press the key.
2
Select the cleaning type by pressing
the keys.
3
Press the key.
• The rest of the cleaning time is indicated at the
lower of the display.
• On completion of cleaning, this machine returns to
LOCAL mode.
4
Perform test printing again, and check the result.
• Repeat the cleaning and the test printing until the drawing result becomes in normal.
When 600cc cartridge is used
Even when [Ink Level] is displayed, enough ink for head cleaning may remain in the ink pack.
When [Ink Level] appears, see P.3-46 “When [Ink Level] is displayed” and enter the current weight of
the 600cc cartridge.
When the remaining ink is not enough for head cleaning
When the remaining ink is not enough for head cleaning, an error
shown on the right appears on the step 3. Replace with a new ink
pack, and then perform head cleaning again.
When the image quality is not improved after the head cleaning.
• Clean the wiper and ink cap. ( P.4-5)
• Wash the head nozzle. ( P.4-10)
• Solve the failure of the image quality, referring to "When Nozzle clogged after cleaning".
(P.4-21)
To Next Page
Loading...
