MIMAKI JV33-130BS - Page 57

This section describes the operation procedures for using the
machine more conveniently and each setting procedure.
User type .............................................. 3-2
Registering the drawing conditions
together (Type registration) ..................3-2
Registering Type ..................................3-2
Setting media compensation.............. 3-5
Setting media compensation ................3-5
Changing the set value of Heater....... 3-8
Changing temperature settings of
Heater ...................................................3-8
Adjusting suitable temperature
adjustment ..........................................3-10
In case the heater temperature is
too low ................................................3-11
Setting print mode............................. 3-12
Setting of the print quality ...................3-12
Setting scanning direction ..................3-14
Setting Logical-seek ...........................3-15
Setting drying time............................ 3-16
Setting margins ................................. 3-17
Setting Priority................................... 3-18
Setting Auto cleaning........................ 3-20
Setting cleaning while printing ........ 3-22
Setting media detection .................... 3-24
Other settings.................................... 3-26
Initializing the settings ..................... 3-28
Machine settings............................... 3-29
Setting the deodorize fan ................... 3-30
Setting Dryness feeding .................... 3-31
Setting Stamp .................................... 3-32
Change the operation condition of
the room temperature ........................ 3-33
When using 600 cc cartridge
(firmware Ver.3.10 or older) ............... 3-34
When using 600 cc cartridge
(firmware Ver.3.20 or later) ................ 3-42
Setting Test draw arrange ................. 3-50
Setting confirmation feeding .............. 3-52
Setting time ........................................ 3-53
Setting Unit ........................................ 3-54
Setting Machine name ....................... 3-55
Setting Key buzzer ............................ 3-56
Extension of Ink Expiry Month......... 3-57
Extension of Ink Expiry Month ........... 3-57
Switch Setting of Ink Supply Path ... 3-59
Confirming machine information..... 3-61
Displaying Information ....................... 3-61
CHAPTER 3
Convenient use