– 4.5 –
FUNCTION
# ADJUST < ENT >
#ADJUST
PRN. adjust 2 < ENT >
4-3. Menu of #ADJUST
4-3-1. PRINTadjust2
This function is used to adjust the relative dot positions between heads after the nozzle BKT
has been replaced.
[Function]
Corrects the dot shot timing between heads into the X and Y directions based on black of the
REAR row.
Correction items and units entered are shown below.
X PRINT Y SINGLE Y REPEAT Y BI-D
between heads colors 1 - 2 0.1 dot units 0.1 dot units none
colors 1 - 3 1 dot units 0.1 dot units 0.1 dot units none
colors 1 - 4 0.1 dot units 0.1 dot units none
colors 1 - 5 1 dot units 0.1 dot units 0.1 dot units none
colors 1 - 6 0.1 dot units 0.1 dot units none
colors 1 - 1 none none none 0.1 dot units
When this operation is executed, the adjustment values of the “PRINTadjust” which is open
to the user become the initial values. This is so that the adjustment values obtained with this
function can be used as a base to which the user correction values can be added to obtain the
actual dot position correction values.
The correction values are stored under the adijut parameters.
[Operation]
1) Select the “ADJUSTMENT.”
Press the
ENTER
key.
2) Select the “PRN.adjust2” pressing the
FUNCTION
key.
Press the
ENTER
key.
3) Select the item to be corrected using the
or key.
Press the
ENTER
key.
• “ADJUST: TEST DRAW” only
plots the test pattern that is used to
check the adjustments. There is no
place to enter correction values.
• If “ADJUST: FINE” is selected,
refer to the section “If FINE has
been selected” below.
#PRN. adjust2
SEL. : Variable-1
#PRN. adjust2
SEL. : Variable-2
#PRN. adjust2
SEL. : Normal-1
#PRN. adjust2
SEL. : Noramal-2
#PRN. adjust2
SEL. : X DIRECTION
#PRN. adjust2
SEL. : BASIS SET
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General
