5-15
Chapter 5 Troubleshooting
1
2
2
2
5
ERROR 432
Take-UP Connect
Take-up device connection destination
error
• Turn off the power button to the machine
and turn it on after a while.
• If the same error message appears
again, contact your local distributor to call
for service.
ERROR 433
Feeding Connect
Feeding device connection destination
error
ERROR 436
Take-UP Fuse Err
Take-up fuse blown
ERROR 437
Feeding Fuse Err
Feeding fuse blown
ERROR 442
Take-UP Voltage
Abnormal voltage of the take-up unit
ERROR 443
Feeding Voltage
Abnormal voltage of the take-up unit
ERROR 44d
STATION POS ERROR
Abnormal station position
ERROR 44e
UV UNIT FAN ERROR
The UV unit fan does not operate.
ERROR 46b
TAKE-UP ENC WRONG
An error occurs in the take-up encoder.
ERROR 46c
FEEDING ENC WRONG
An error occurs in the feeding encoder.
ERROR 50a
Y ORIGIN
Y-origin could not be detected.
ERROR 50c
MEDIA WIDTH SENSOR
The media width has not been detected
correctly.
• Check the media set position.
• Clean the media sensor. ( P.4-3)
ERROR 50f
L-SCALE BLACK
Abnormal linear scale.
• Turn off the power button to the machine
and turn it on after a while.
If the same error message appears
again, contact your local distributor to call
for service.
ERROR 516
MEDIA SET POSITION R
The media is set outside the proper area. • Check the media set position.
ERROR 516
MEDIA SET POSITION L
ERROR 531
INKTNK SENS:MCYK
The weight balance is abnormal.
• Make sure the ink supply unit is
connected to the machine.
• Check if any weight or load is taken on
the ink tank.
• Implement the "Tank Calibration" of the
Maintenance menu, and perform the
correction of the balance.
• If the same error message appears
again, contact a distributor in your district,
our office, or our call center.
ERROR538
CHECK MEDIA SET POS.
The media is not set in the correct position. • Check the media set position.
ERROR 607
CAP CLEANING
Time to clean the cap
• Perform the station maintenance, and
clean the cap.
ERROR 618
TANKlevelH :1234
The sub tank sensor High does not change
though a certain amount of ink has been
consumed.
• Perform “SUBTANK” of the maintenance.
(P.5-4)
Even if you perform, it may be displayed,
contact your local distributor to call for
service.
ERROR 61a
InkOverflow :1234
Ink has entered the air tank.
Message Cause Solution
To Next Page
Loading...
