MIMAKI SWJ-320EA - Chapter 2: Basic Operations; Operational Workflow

This chapter
describes procedures and setting methods for ink and media preparation, and printing.
Workflow .......................................................2-2
Turning the Power ON/OFF ..........................2-3
Turning the Power ON ................................ 2-3
Turning the Power OFF ............................... 2-3
Setting a Media .............................................2-4
Note for media setting ................................. 2-4
Setting a roll media ..................................... 2-4
Setting a narrow roll media ......................... 2-8
Setting two narrow roll media
(twin rolls) .................................................. 2-12
Setting leaf media ..................................... 2-15
Removing the taken-up media .................. 2-15
Changing the printing origin ...................... 2-16
Preparing for the Heaters ............................2-17
Changing the Temperature Settings for the
Heaters ...................................................... 2-17
Test Printing ................................................2-17
Test Printing ...............................................2-18
Head Cleaning ............................................2-18
About head cleaning ..................................2-18
Perform head cleaning depending on the test
printing result .............................................2-18
Setting of Media Correction .........................2-19
Setting of Media Correction .......................2-19
Correct the ink drop position for bidirectional
printing ........................................................2-20
Printing Data ...............................................2-21
Starting a Printing Operation .....................2-21
Stopping a Printing Operation ....................2-21
Deleting Received Data (Data Clear) ........2-21
Chapter 2
Basic Operations