MIMAKI SWJ-320EA - Setting of Logical Seek; Setting of Overprint; Setting of Drying Time

3-7
Chapter 3 Setup
3
2
2
Setting of Logical Seek
The head’s operation varies depending on the Logical
Seek settings, as shown in the figure below.
1
Press the
(MENU)
key in
Local.
2
Press to select SETUP 1 to 4,
and press the key.
• Setup menu appears.
3
Press to select “Logical Seek”,
and press the key.
4
Press to select a set value, and
press the key.
• Set value : Data/ Media/ Quality
5
Press the key several times
to end the setting.
Setting of Overprint
Sets the number of layers in which ink is to be applied.
1
Press the
(MENU)
key in
Local.
2
Press to select SETUP 1 to 4, and
press the key.
• Setup menu appears.
3
Press the
(>>)
.
4
Press to select “Overprint” , and
press the key.
5
Press to set number of Overprint,
and press the key.
• Setting value : Host/ 0 to 9 times
6
Press the key several times to
end the setting.
Setting of Drying Time
In the drying time setting, the following items for ink drying
time are set.
• SCAN : Ink drying time for each scanning is set. (During
bidirectional printing, the machine stops for a
certain period of time specified for each of the
outward and return scanning.)
1
Press the
(MENU)
key in
LOCAL.
2
Press to select SETUP 1 to 4,
and press the key.
• SETUP MENU will be displayed.
3
Press to select “DRYING TIME”,
and press the key.
If the Logical Seek is set to “Data” or “Media”, the
following phenomena may occur. In such a case, set
the Logical Seek to “Quality”.
• The accuracy of the media feed amount is
lowered.
• Media skews.
• Lateral stripes occur due to feed variations.
UNI-DIRECTIONAL BI-DIRECTIONAL
Movement of heads when Logical Seek is “Media”.
Movement of heads when Logical Seek is “Data”.
UNI-DIRECTIONAL BI-DIRECTIONAL
Media
Red arrow : Movement of head
Print area
Red arrow : Movement of head
Print area
Media
Media Media
UNI-DIRECTIONAL
BI-DIRECTIONAL
The head moves twice the distance of longer side of the set
media from the center of the platen as a reference.
Media
Movement of heads when Logical Seek is “Quality”.
Red arrow : Movement of head
Print area
Red arrow : Movement of head
Print area
Center
Media
• When you give priority to the setting at the
RasterLink side, make the setting value “Host”.
• “SCAN” set in this machine is displayed as “Pause
Time per Scan” in the RasterLink.