3-13
1
2
3
4
5
6
Chapter 3 Mchine setting
Setting a AUTO Power-off
When no operation has been performed for the set time,
the power supply is automatically turned “OFF”.
1
Press the
(MENU)
in Local.
2
Press to select “Machine Setup”,
and press the key.
3
Press to select “AUTO POWER
OFF”, and press the key.
4
Press to select a set value, and
press the key.
• Set Value : none, 10 to 600min
5
Press the key several times to
end the setting.
Setting Feeding unit
For setting whether the Feedibg unit is used or not used.
1
Press the
(MENU)
in Local.
2
Press to select “Machine Setup”,
and press the key.
3
Press to select “Feeding Unit” ,
and press the key.
4
Press to select a set value, and
press the key.
• Set Value : ON/ OFF
5
Press the key several times to
end the setting.
Setting Take-up unit
For setting whether the take-up unit is used or not used.
1
Press the
(MENU)
in Local.
2
Press to select “Machine Setup”,
and press the key.
3
Press to select “Take-up Unit” ,
and press the key.
4
Press to select a set value, and
press the key.
• Set Value : ON/ OFF
5
Press the key several times to
end the setting.
Network &
Mail
Event Mail
(P.3-16)
Transmit
Tes t
Send the test e-mail.
Setting Lock
( P.3-20)
Lock
(Password is
not set)
0000 to 9999 0000
You can freely specify a four digit password so
that no one other than an administrator can
perform network and mail settings.
Unlock
(Password
is set)
Reset
( P.3-20)
All setting values are returned to the status
default.
*1. Settable when both of DHCP and AutoIP are [OFF]
*2. Settable only when Auth. is not OFF
*3. Settable only when Auth. is POP before SMTP
Function name Set value Default Meaning
• If the machine received data from the PC in the
auto-power-off status, the power supply is turned
ON, however, printing operation is not started
automatically.
To Next Page
Loading...
