3-15
3
2
2
Setting the Display of Media Detec-
tion
Set the following two items in media detection settings.
1
Press the
(MENU)
in Local.
2
Press to select “Machine Setup”,
and press the key.
3
Press the
(>>)
.
4
Press to select “Media Detect”,
and press the key.
5
Press to select AUTO/MANUAL,
and press the key.
6
Press the key several times to
end the setting.
Setting the CONFIRM. FEED
Set whether media feeding is performed for checking the
result of the test printing etc. or not.
1
Press the
(MENU)
in Local.
2
Press to select “Machine Setup”,
and press the key.
3
Press the
(>>)
.
4
Press to select “CONFIRM.
FEED” , and press the key.
5
Press to select a set value, and
press the key.
• Set value : ON/ OFF
6
Press the key several times to
end the setting.
Set the network
1
Press the
(MENU)
in Local.
2
Press to select “Machine Setup”
and press the key.
3
Press the
(<<)
.
4
Press to select “Network & Mail”
and press the key.
5
Press to select “Network” and
press the key.
6
Press to select “Check IP
Address” and press the key.
• The IP address currently used by this machine is
displayed.
7
Press to select “Check MAC
Address” and press the key.
• The MAC address currently used by this machine
is displayed.
8
Press to select “DHCP” and
press the key.
•Press [][] to set ON/ OFF.
• When it is ON, the IP address given by the DHCP
server is used.
9
Press to select “AutoIP” and
press the key.
•Press “”“” to set ON/ OFF.
• When it is ON, the IP address is determined by
the AutoIP protocol. However, DHCP is ON,
DHCP has priority.
10
Press to select the set values
and press the key.
• Both of DHCP and AutoIP is OFF, you can set IP
Address/ Default Gateway/ DNS Address/ Sub
Net Mask. For other than above, proceed to the
Step 13.
Setting of Media
Detection
When loading the media, set whether
to detect the media width automatically
(AUTO) or decide the print range
manually (MANUAL).
• When using the media that cannot be detected by
the sensor, set the media detection setting to
"MANUAL".
• When “MANUAL” is selected, the values of
“MARGIN (RIGHT/LEFT)” on the SETUP MENU
have no effect. ( P.3-8)
• After connecting with the network, it takes time
until the IP address is determined.
If the IP address has not been determined,
“0.0.0.0” is displayed.
To Next Page
Loading...
