4-9
4
2
Chapter 4 Maintenance
3
Press to select “Pump Tube
Wash”, and press the key.
• Press the [ENTER] key in the Execution Check
screen, and the carriage moves over the platen.
• Dry suction operation is performed repeatedly
until the washing work is completed.
4
Open the right side maintenance cover.
(1) Rotate the screws under the right side
maintenance cover (for two positions) to the
left and remove them.
(2) Hold the bottom of the right side
maintenance cover and pull it to the front.
(3) While pulling the right side maintenance
cover downward, remove it.
• If the right side maintenance cover is hard to
remove, use the supplied screwdriver.
5
Suction the cleaning solution into a
syringe and squirt about three syringes
worth of solution into each cap.
6
Close the right side maintenance cover
and press the key.
• After running a dry suction for a certain period of
time?the screen returns to step2.
When the Machine Is Not Used for a
Long Time (Custody Wash)
When the machine is not going to be used for a week or
more, use the cleaning function for custody to clean the
head nozzles and ink discharge passage.After this, keep
the machine in custody.
1
Press the
(TEST PRINT/CLEANING)
,
and press the key in Local.
2
Press to select “Station”, and
press the key.
• The Station MENU appears.
3
Press to select “Custody Wash”,
and press the key.
• Press the [ENTER] key in the Execution Check
screen, and the carriage moves over the platen.
Right side
maintenance cover
Screw
Check the items on the right beforehand.
Is [NEAR END] or [INK END] displayed?
• The cleaning solution or ink is absorbed when the nozzles
are washed.
At this time, if the state of "no ink" or "almost no ink" is
detected, the nozzle washing operation cannot start.
• Refill ink.
• Be sure to use the dedicated washing liquid for
maintenance (SPC-0369).
• Until wiper/ bracket cleaning is competed, [Please
clean the wiper.] is displayed on the screen. After
the work up to the step 5 is completed, press the
[ENTER] key.
To Next Page
Loading...
