MIMAKI SWJ-320EA - Waste Ink Handling and Disposal

4-16
Chapter 4 Maintenance
Setting the Cleaning level
The head cleaning level is set.
1
Press the
(MENU)
in Local.
2
Press to select “Maintenance”,
and press the key.
• Maintenance MENU appears.
3
Press to select “Auto Maint.”,
and press the key.
4
Press to select “Cleaning”, and
press the key.
5
Press to select the cleaning level,
and press the key.
• Set value : OFF/Lv.1/Lv.2/Lv.3
6
Press to select the cleaning type,
and press the key.
• Set value : Soft/ Normal/ Hard
7
Press the key several times to
end the setting.
Discarding waste ink
1
Remove the waste ink tank.
• Pull out the tube inserted into the waste ink tank,
and take out the waste ink tank.
2
Replace the waste ink tank.
• Prepare a new waste ink tank.
3
Return the empty waste ink tank to the
original position.
• Reinsert the tube pulled out.
• Discard waste ink frequently.If left for a long time,
the ink in the waste ink tank may be cured or
overflow.
• When disposing of the waste ink, be sure to wear
attached safety glasses and gloves to perform the
work. Otherwise, you may get ink in your eyes.
• If you get the ink on your skin or in your eyes,
wash it away with plenty of water immediately.
• When pulling out the tube, ink may drop from the
tip of the tube. Wipe the tube with waste cloth and
cover the tip before starting work.
• Request the treatment of waste ink for an
industrial waste disposal contractor.
• A part of the ingredients (photo polymerization
initiator) has toxicity against aquatic organisms.
Please prevent leakage flow to natural water
systems (river, etc.) and domestic sewages (toilet,
road, etc.)
Tube