MIMAKI SWJ-320EA - Replacing the Cap Absorber

4-22
Chapter 4 Maintenance
8
Refer to “Fill ink in the ink tank and
charging” on.
Replacing the cap absorber
Replace once a year or when ink is adhering to
approximately 50% of absorber surface.
1
Press the
(TEST PRINT/CLEANING)
,
and press the key in Local.
2
Press to select “Station”, and
press the key.
• The Station MENU appears.
3
Press to select “CARRIAGE
OUT”, and press the key twice.
• The carriage moves onto the platen.
4
Open the right side maintenance cover.
(1) Rotate the screws under the right side
maintenance cover (for two positions) to the
left and remove them.
(2) Hold the bottom of the right side
maintenance cover and pull it to the front.
(3) While pulling the right side maintenance
cover downward, remove it.
• If the right side maintenance cover is hard to
remove, use the supplied screwdriver.
5
Remove the plates (front and rear)
retaining the absorber.
6
Install a new absorber.
7
Tighten the screws while pressing in.
8
Close the right side maintenance cover,
and press the key.
• Do not tighten the joint too much. Otherwise, the
filter might be damaged. Be careful.
• Do not pour the ink remaining in the removed ink
tank into the new tank.
• Request that an industrial waste disposal
company process the disposal ink.
• When the tube and cover are in contact, there are
times when the amount of ink can not be
accurately detected. So as not to contact to the
utmost as shown in the figure below, please be
careful for the direction of the joint.
Carriage
Right side
maintenance cover
Screw
Plate
Absorber