MIMAKI TS34-1800A - Setting Leaf Media

2-14
Setting leaf media
Unlike roll media, leaf media does not need to be retained with the roll holders.
1
Open the front cover.
2
Raise the clamp lever.
3
Insert the leaf media between the platen and the
pinch rollers.
• Set the media so that no media sticks out from the right end
pinch roller to the right side.
4
Hold the media with the media press gently.
• Set the media so that no media sticks out from the right end
pinch roller to the right side.
• When using a thick media, remove the media press from
the media before printing.
5
Push down the clamp lever.
• Set the media straight.
6
Close the front cover.
7
Press the key.
8
Press the key to select "LEAF" .
Front cover
Clamp lever
Pinch roller
Media press
MED I A SE L EC T
ROL L < > L EAF