MIMAKI TS34-1800A - Media Cutting Operations

Printing Data
2-22
Cutting a media
For a roll media, two ways are available to cut the media after printing is completed, as follows.
Auto cut
A media is automatically cut after printing is completed.
1
When printing has been completed, the media is
cut automatically.
Manual cut
By using the keys on the operation panel, you can cut the media at any position.
1
In LOCAL, Press .
• LOCAL changes to the origin setting mode.
• By pressing , feed the media to the cutting position.
2
Press the key.
3
Press the key.
• The media is cut.
• When the cutting has been completed, the current mode returns to LOCAL.
• When a media is cut, be careful that the printed side does not touch the floor or the printed side of
other already cut media.
• When using the take-up device, take up a cut media using the switch of the take-up device.
• In order to activate the automatic cutting function, the setting for it needs to be configured. (For the
detailed setting method, refer to P.3-23. The automatic cutting function is set to "HOST" as default.)
• When the automatic cutting function is "OFF", perform the operation in “Manual cut” described later to
cut a media.
OR I G I N SETUP
0.0 ----
MED I A CUT
<ENT>
MED I A CUT T I NG
PLEASE WA I T