Chapter 4 Try cutting data with registration marks
104
4.4 Detecting the Position of the Register
Mark Origin
1
In LOCAL mode screen, select [TEST CUT].
width:1340mm
PRTOOL
TEST CUT
LOCAL
2
Select [Mark Detection], then press the [ENTER] key.
• The machine switches to TP DETECT mode.
• The cutting unit moves over the platen.
• If the machine does not switch to TP DETECT mode, set the [TEST CUT] > [TP Dect
Setup] > [TP DETECT] setting to “ON”.
3
Press to move the LED pointer to the center of the register mark.
Mark shape
Type 1 Type 2
4
Press the [ENTER] key.
• Register mark detection starts.
To Next Page
Loading...
