MIMAKI UCJV300-107 - Page 171

Chapter 7 Troubleshooting
171
3
Click on [print & cut Origin adjust] on the [Cut edit] tab of RasterLink.
• Click [OK] to print a correction pattern.
• Select "Add register mark” to print with register marks.
4
Enter the adjustment value.
• Without register marks
(1) In LOCAL mode, select [ADJUST].
(2) Select [PC ORIGIN OFFSET], then press the [ENTER] key.
• A correction pattern is cut. Detach the cut part of the pattern and check the adjustment
values.
+-
-+
(3) Input the numerical value of the position with the lowest vertical misalignment.
• Enter “-4” in the illustration shown below.
-2 -5-4-3 -6
X enlarged
(4) Input the numerical value of the position with the lowest horizontal misalignment.
• Enter “-2” in the illustration shown below.
4 123 0
Y enlarged
• With register marks
(1) In LOCAL mode, select [ADJUST].
(2) Select [TP OFFSET], then press the [ENTER] key.
• The register marks are detected, and a correction pattern is cut. Detach the cut part of the
pattern and check the adjustment values.
• The remaining steps are the same as those for “Without register marks”.
7