Chapter 4 Maintenance
102
4
Soak up any ink droplets on the special caps.
• Use a wipe filter to soak up ink droplets and prevent dripping.
5
Wipe off any ink on the special caps with paper wipes.
6
Shake the ink bottle to the left and right slowly at least 20 times.
• Tighten the special cap securely, then shake the bottle slowly from left to right by holding the
special cap with a paper towel, to ensure that the ink moves inside.
• Shake slowly. If the bottle is shaken too violently, ink may leak out or the air mixed in the
ink may cause nozzle clogging.
• When fitting a bottle with only a small amount of ink inside, flip the ink bottle upright and
shake slowly at an angle.
To Next Page
Loading...
