MIMAKI UJV100-160 - Error messages

Chapter 5 Dealing with Problems
124
Error messages
Error
number
Message Cause Corrective action
04 PARAM ROM
• A problem was detected with
the main PCB.
• Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
108 HD THERMIS [1234]
• A problem was detected with
print head temperature
control.
• Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
108 HD CONNECT [1234]
• A problem was detected with
the print head connection.
122 CHECK:SDRAM
• A problem was detected with
the SDRAM.
• Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
128 HDC FIFO OVER
• A problem was detected with
the print head control PCB.
128 HDC FIFO UNDER
129 Battery Exchange
• The internal clock battery is
spent and must be replaced.
• Contact your local distributor, our sales
office, or service center.
12a HDC SPEED
• A problem was detected with
the print head control.
• Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
130 HD DATA SEQ
148 E-LOG SEQ
• A problem was detected with
log control.
• Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
151 Main PCB V1R2
• A problem was detected with
the main PCB power supply
circuit.
• Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
152 Main PCB V2R5
153 Main PCB V3R3
154 Main PCB V05
157 Main PCB VTT
158 Main PCB V36-2
15f HEAD DRIVE HOT
• The COM drive has
overheated.
• Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
16e Main PCB V3R3B
• A problem was detected with
the main PCB power supply
circuit.
171 NEW HEAD CONNECT
• A new print head connection
was detected.
18a Main PCB V_CORE
• A problem was detected with
the main PCB power supply.
• Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
18b Main PCB V1R5B
18c Main PCB V12
18e FLS NOT COMP
• A problem was detected with
the print head control.
• Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
18f OFSET START
18f OFSET END
19f LED CONNECT
• The UV-LED PCB could not
be detected.
• Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
1d9 Main PCB V48-1
• A problem was detected with
the main PCB power supply.
• Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)