Chapter 5 Dealing with Problems
125
Error
number
Message Cause Corrective action
1e6 PRAM Size Shortage
• Insufficient memory • Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
201 Command Error
• Data other than print (RIP)
data was received, or a
problem was detected with
the print (RIP) data received.
1. Clear the data and resend.
2. Check the USB cable connection.
"Using a USB 2.0 Interface
Cable"(P. 33)
3. Use a compliant USB cable. "USB
2.0 Interface Precautions"(P. 33)
4. Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
202 Parameter Error
• A problem was detected with
the print (RIP) data received.
206 Printing Mode
• Print (RIP) data was received
with print parameters that do
not allow printing.
• Change the output parameters and
profile using RIP software.
304 USB INIT ERR
• A problem was detected with
the USB cable connection.
1. Check the USB cable connection.
"Using a USB 2.0 Interface
Cable"(P. 33)
2. Use a compliant USB cable. "USB
2.0 Interface Precautions"(P. 33)
3. Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
305 USB TIME OUT
307 MCFD File IF Error
• A problem was detected
while accessing print
parameter data.
• Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
401 Motor X
• The X motor was overloaded. 1. Check to confirm the media is loaded
correctly. "Loading the
Media"(P. 53)
2. Open the front cover and check for
anything that may obstruct carriage
movement.
3. Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
402 Motor Y
• The Y motor was overloaded.
403 X Current
• An overcurrent was detected
in the X motor.
404 Y Current
• An overcurrent was detected
in the Y motor.
44e UV Unit Fan Error
• A problem was detected with
the UV-LED unit fan.
• Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
44f Take-up Roll Sns Err
• A problem was detected with
the take-up unit sensor
spindle.
1. Check to confirm the [Machine Setup] >
[ Feeding/Take-up] > [Take-up Unit]
setting is “ON”.
2. Check to confirm the media is loaded
correctly. "Loading the Roll
Media"(P. 53)
3. Check to confirm the take-up unit switch
functions properly. "Take-up
Unit"(P. 24)
48a Detect winding failure
• The take-up unit is unable to
take up media.
• Check to confirm the media is loaded
correctly. "Loading the Roll
Media"(P. 53)
504 CLAMP UP
• The clamp lever is lifted. • Lower the clamp lever.
505 Media Jam
• The media jam sensor was
triggered.
1. Remove the media in contact with the
carriage and reload with fresh media.
"Loading the Media"(P. 53)
5
To Next Page
Loading...
