MIMAKI UJV100-160 - Page 126

Chapter 5 Dealing with Problems
126
Error
number
Message Cause Corrective action
2. Open the front cover and check for
anything that may obstruct carriage
movement.
509 HDC POSCNT
• A problem was detected with
position control.
• Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
50a Y Org Detect Error
• A problem was detected with
Y origin detection
(initialization).
50c Media Width Sensor
• A problem was detected with
media width detection.
1. Check the media loading position.
"Loading the Media"(P. 53)
2. Clean the media width sensor.
"Media Sensor Cleaning"(P. 95)
50f L-SCALE BLACK
• A problem was detected with
the linear scale.
• Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
516 Media Set Position R
• The media was loaded
outside the range of valid
positions.
1. Check the media loading position.
"Loading the Media"(P. 53)
2. Clean the media width sensor.
"Media Sensor Cleaning"(P. 95)
525 Wrong Ionizer
• The ionizer internal circuit is
defective, or an abnormal
discharge occurred.
• Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
526 Ionizer Ion Level
• The amount of generated
ions was reduced by fouling
and abrasion of the electrode
needle.
• Refer to the instruction manual for the
ionizer and clean the electrodes.
527 Ionizer Condition
• Ambient conditions may
cause ions to be absorbed by
metals in the vicinity and
affect discharge capability.
• Remove any conductors or discharge
devices close to the ionizer.
528 Pump Motor Sensor
• A problem was detected with
the pump motor.
• Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
52f Carriage Org
• The carriage control origin
has not been set.
• Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
530 Station Org
• The station control origin has
not been set.
536 Station Lock
• A problem was detected with
the station.
• Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
549 LEnc. Count DIO
• A problem was detected with
the linear scale wiring to the
DIO PCB.
• Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
608 Wrong Ink IC
• An error occurred with the
information on the ink IC
chip.
1. Check to confirm the ink IC chip was
inserted correctly.
2. Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
3. Replace with new ink.
64C NCU Error
• The function is disabled due
to an error.
• Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
650 NCU CONNECT
• A problem was detected with
the NCU connection.