MIMAKI UJV100-160 - Page 127

Chapter 5 Dealing with Problems
127
Error
number
Message Cause Corrective action
651 Replace NCU
• A problem was detected with
the nozzle clogging
assessment.
• The NCU must be replaced. Contact
your local distributor, our sales office, or
service center.
652 NCU NZK CHK (HW)
• A problem was detected with
the nozzle clogging
assessment.
• Clean the NCU. "NCU
Cleaning"(P. 90)
653 NCU NZK CHK (Mark)
654 NCU CENTER POS
• Printing position adjustment
failed.
655 NCU FLUSH POS
656 NCU SN ADJST
• Sensor sensitivity adjustment
failed.
657 Replace NCU Ink Pad
• The NCU ink absorber is full. • The NCU ink absorber must be
replaced. Contact your local distributor,
our sales office, or service center.
658 NCU Sensor Lv Low
• The sensor’s sensitivity is
impaired.
• Clean the NCU. "NCU
Cleaning"(P. 90)
• Replace the NCU if the error does not
clear. Contact your local distributor, our
sales office, or service center.
65b NCU Sens Adj Err H
• Sensor sensitivity adjustment
failed.
65c NCU Sens Adj Err L
702 Thermistor Connect
• A problem was detected with
the thermistor connection.
• Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
710 Heater Temp Error
• A problem was detected with
the heater temperature.
• This error will be automatically resolved.
If not,
Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
715 InkHeater Thr
• A problem was detected with
the ink heater thermistor.
• Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
716 InkHeater Tmp
717 InkHeater Brk
71a UV-DRV Fuse
• A UV-DRV PCB fuse blew.
901 INVALID OPERATE
• The function is disabled due
to an error.
• Check the error details.
902 Data Remain
• Print (RIP) data was
received.
• Switch to REMOTE mode and start
printing or clear the data and abort
printing.
90d No Head Select
• A problem was detected with
the print head.
• Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
90f Print Area Short
• The media is too small for the
print.
• Replace with wider or longer media.
• If the printable area is reduced due to a
shift in the origin, move the origin to
increase the size of the printable area.
91a Adjust Head Height
• The registered print head
height differs from the height
of the actual product.
• Adjust the print head height.
"Adjusting Print Head Height"(P. 51)
b0f DIO PCB Uvpow
• A problem was detected with
the UV-DRV PCB power
supply voltage.
• Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
b1b BaseIO PCB Vpow-s
• A problem was detected with
the Base IO PCB power
supply.
• Turn off the power on the machine and
turn it on after a while. "Turning Off
the Power"(P. 31)
b1c BaseIO PCB V24
5