4-24
Chapter 4 Maintenance
8
Remove the ink tank of the selected slot
and press the key.
(1) Remove the ink filter attached to the ink tank.
• Loosen the joints on the top of the ink filter,
and remove the filter.
(2) Tilt the ink tank to the front and remove.
9
Place the 1kg weight on the dish of the
balance of selected slot and press the
key.
• Process the correction.
10
When the correction processing is finished
successfully, remove all the weights on the
dish of the balance and press the
key.
• Perform the correction processing without the
weight on the balance.
11
When the correction processing is finished
successfully, set the ink tank that was removed
in step 8 and press the key.
Correct by the correction method
“Adjust Zero Pos.”
1
Press the
(MENU)
in LOCAL.
2
Press to select “Maintenance”,
and press the key.
3
Press the
(>>)
.
4
Press to select “Tank
Calibration”, and press the key.
5
Press to select “Adjust Zero
Pos.” and press the key.
6
Press to select an ink tank (ink
color) to be corrected, and press the
key.
7
Remove the ink tank of the selected slot
and press the key.
• Perform the correction processing without the
weight on the balance.
8
When the correction processing is finished
successfully, set the ink tank that was
removed in step 7 and press the
key.
• Please put the weight in the center of the dish of
the balance.
If you put weight on the edge of the dish, it will
cause to increase the error of the remaining
amount detection.
• During the correction process, please do not give
vibration to the ink supply unit. There is a
possibility to fail the correction process.
• When the correction process fails, “Failed” will be
shown on the display. Press the [ENTER] or [END]
key, and change the position or the load of the
weight.
• During the correction process, please do not give
vibration to the ink supply unit. There is a
possibility to fail the correction process.
• When the correction process fails, “Failed” will be
shown on the display. Press the [ENTER] or
[END] key to clear the error display and press
again the [ENTER] key. It will resume the
correction processing.
• During the correction process, please do not give
vibration to the ink supply unit. There is a
possibility to fail the correction process.
• When the correction process fails, “Failed” will be
shown on the display. Press the [ENTER] or
[END] key to clear the error display and press
again the [ENTER] key. It will resume the
correction processing.
To Next Page
Loading...
